男同用品gay仿精液水溶性润滑液

Product Rating:

Product Review (submitted on June 17, 2013):

Lots of little issues, but nothing that can't be overcome by a person with a moderate amount of experience. First the positives, the covering and look of this model is really nice. The colors are nice, the scheme is attractive, and the covering was smooth and unblemished. It looks like it is fairly well constructed. I checked all the joints I could see and it looked like it was assembled pretty good.

The negatives: The instructions are poor. Section 4 seems to omit how to mount the elevator on the horizontal stab. The two elevators are supposed to have a pre-drilled hole for connecting rod. Mine didn't have holes in either elevator. The tail wheel in the kit is different then the one shown in the instructions, plus the rod is not pre-bent for installation into the balsa of the rudder. The connecting rod clevis (how do you say multiple clevises? clevi?) didn't seen to have the pins to close them. I threw them away and went with Sullivan's. I received two nylon wing bolts, but two different sizes. Both supposed to be a 5mx20, but one seems to be a 4mX20. Finally, the engine mount does not install centered to the fuselage. A little bit of the plywood had to be ground away by my Dremel to make sure the cowl fits nicely. The wheel pants are kinda dodgy too, but they work.

I mounted the recommended GForce G32 motor, Towerpro MG996R metal gear servos, and a 70A ESC from another vendor. So far, no batteries soof course I haven't flown it yet.

Overall, very good value for the money, but it definitely isn't a shake and bake kit that goes together without a problem. VH (that's not Van Halen) needs to take a few hours and improve/clarify the instructions. I recommend, but with some reservations.