Designed for use with small indoor or small to mid-sized outdoor multirotor crafts, or as a standalone camera stabilizer. The Naze32 flight controller is extremely simple to setup, with configuration based on the familiar MultiWii software. The Acro version is the same as the full Naze32 board except the full version comes with the MS5611 barometer and a magnetometer. Also includes custom hard case to fit the board.

Features:

• USB on right side
• PPM/PWM input as through-hole
• 3.3V, I2C on standard-size headers
• Fully pinout compatible with rev5 accessories (OSDoge etc)
• SBUS Inverter
• Spectrum satellite
• MPU6500
• Sonar pads w/resistors added for direct connection to 5V sonar
• All extra pads (FT, GP, A5) on top, only sonar on bottom
• 16mbit flash

Specifications:

• Flashed using Baseflight from the factory.
• 36x36 mm (30.5mm Mounting)
• 5.3 grams (no headers, 7.3 grams with)
• 2000 degrees/second 3-axis MEMS gyro + accelerometer (MPU6500)
• Input voltage: Max 16V on input rail and up to 35V 6s on the voltage sense line

Package includes:

• Acro Naze32 6DOF rev6
• Break out PWM cable
• 2x5 pin header
• 2x3 pin header (right angle), 2x3 pin header (straight)
• 3x6 pin header (right angle), 3x6 pin header (straight)
• 1x10 pin header