The G10 (35-36) brushless out-runner motor can replace a .15 - .25 two stroke nitro engines and is equivalent to E-Flite Power 10 / AXI 2814. It is capable of producing up to 3.5 lb of thrust and generate about 450W of power.Bullet connectors are NOT soldered. You will need to install your own connector.

Prop adapter and radial mount accessories are included.

Specifications:

• KV: 1300.
• Weight: 3.7oz (105g) for motor only, not including mounting accessories.
• Motor Diameter: Approx. 35mm
• Connector: 3.5mm bullet connector
• Shaft diameter: 4 mm
• Max efficiency: Approx. 30A
• Max Load: Approx. 35A

Recommended Setup:

• 40A  brushless motor ESC
• 3S LiPO and at least 2200mAh.
• Prop Selection: Remember to always use props designed for electric motors, nitro props are heavier and might overload the motor.
  With 3S LiPO: 10x5, 9x6
• The above prop selections are recommended for sports flying at open throttle. You may try using larger props if you do not fly at constant open throttle.

Motor Dimensions:

Included Accessories:

This motor includes prop adapter and radial mount shown below. 3.5mm bullet connectors need to purchase separately(SKU: AMS-AC-1476).

Mounting Options:

The included accessories allow you to mount the motor in front of the firewall. Shown below is the motor with radial mount installed on the back and prop adapter installed on the front, ready to be installed in front of the firewall.

If you would like to mount it behind the firewall, you will need to purchase the 4mm Collet Adapter.